For devices that deliver instant beverages, proceed with
the disassembling as follows:
- Disconnect the hoses from the mixer connections
- Turn the mixer locking ring counterclockwise and re-
move the mixer
Pay special attention to lock it totally when assembling
it again;
- Separate the instant powder funnel, the powder tray
and water funnel
5
4
3
2
1
6
Fig. 28
1- Instant powder funnel
2- Instant powder tray
3- Water funnel
4- Mixer fan
5- Instant beverage hose connection
6- Water funnel fixing ring
- Take apart the fans of the motor-mixers; simply pull
gently to free them
Fig. 29
- Dip the parts for approx. 20 minutes in a recipient con-
taining the previously prepared sterilising solution.
Wash all the components with sterilising products (fol-
low the dosage indicated by the manufacturer), being
careful to mechanically remove the visible residues
using brushes if necessary.
- Verify that the shaft seal of the motor mixer is not torn
and has not lost its elasticity.
- Reinstall the powder deposit drawers and the powder
funnels after having carefully rinsed and dried them.
- Place the mixer back into position, properly inserting
the water funnel
Fig. 30
-
Wash the mixer and add a few drops of the sanitizing
solution to the various funnels and rinse thoroughly to
remove any possible residue of the solution used.
To Next Page
Loading...