VENTO MOTORCYCLES
Rev no.01/ page 6of 84
BREAK-IN PROCEDURES
During manufacture only the best possible materials are used and all machined parts are finished to a very high
standard but it is still necessary to allow the moving parts to ‘‘BREK-IN’’ before subjecting the engine to maximum
stresses. The future performance and reliability of the engine depends on the care and restraint during its early life.
General requirements are as follows
Limit break-in speed
At the first 1000 Kms (630 miles, mileage use throttle opening less than 1/2.
Up to 1600 Kms1000 milesmileageuse throttle opening less than 3/4.
• Upon reaching an odometer reading of 1600 Kms (1000 miles) you can operate the motorcycle to full throttle
operation.
• Do not maintain constant engine speed for on extended time period during any portion of the ‘‘BREAK-IN’’
period, try to vary the throttle position.
To Next Page
Loading...