Vento Phantom R4i - Lighting and Meter Systems

VENTO MOTORCYCLES
Rev no.01/ page 75of 84
HEAD LIGHT INDICATOR & METER LIGHT
HEAD LIGHT DISASSEMBLY
Remove front cover
Headlight
Leg shied
Remove headlight bulb-12V18W/18W×2by unscrewing fixing screw
adjust focus through adjusting nut
remove and install night small light-12V3 W×2
HEAD LIGHT ASSEMBLY
The assembly sequence is the reverse of disassembly.
INDICATOR BULB
Remove Indicator
Remove and replace bulb-12V10 W
SPEEDOMETER DISASSEMBLY
Remove front cover of handlebar
Remove connector of headlight
Take out flasher from its retainer and remove connector
Remove fixing screw
Front board, back board
Remove rotating meter and the core of odometer
Replace bulbincluding high beam, turning signal light, fuel gauge, meter indicator light
SPEEDOMETER ASSEMBLY
The assembly sequence is the reverse of disassembly.