05 / CONFIGURING
ADVANCED SETTINGS
109
http://setup.verizon.com/businessinternetgateway |
©2024 Verizon. All Rights Reserved
If DHCP Server is enabled on your Gateway, configure the network
devices as DHCP Clients. There are 2 basic options in this section:
Disabled and DHCP Server.
To set up the Gateway’s network bridge to function as a DHCP
server:
1. In the IP Address Distribution section, select the DHCP
server. Once enabled, the DHCP server provides automatic IP
assignments (also referred to as IP leases) based on the preset
IP range defined below.
– Start IP Address – Enter the first IP address in the IP
range that the Gateway will automatically begin assigning
IP addresses from. Since your Gateway’s IP address is
192.168.0.1, the default Start IP Address is 192.168.0.2.
– End IP Address – Enter the last IP address in the IP range
that the Gateway will automatically stop the IP address
allocation at. The maximum end IP address range that can
be entered is 192.168.0.254.
2. If Windows Internet Naming Service (WINS) is being used, enter
the WINS Server address.
3. In the Lease time in minutes field, enter the amount of time a
network device is allowed to connect to the Gateway with its
currently issued dynamic IP address.
• IP Address Distribution According to DHCP option 60 (vendor class
Identifier)
DHCP vendor class is related to DHCP option 60 configuration within
the Gateway. Adding option 60 configurations allows a particular
vendor to get a lease from a specified pool of addresses.
To Next Page
Loading...
