SETTING UP VERIZON bUSINESS INTERNET
GATEWAY
1.2 c/ SETTING UP
Before you begin, if you are replacing an existing gateway, disconnect it. Remove
all old gateway components, including the power supply. They will not work with
the new Verizon Business Internet Gateway.
1. Before you use your Verizon Business Internet Gateway, be sure to
charge the battery for at least three hours to ensure a full initial charge.
i. It normally takes at least 3~5 hours with the wall charger to fully
charge the battery.
ii. The battery discharges faster as additional devices connect with
your Gateway.
iii. Battery life depends on the network, signal strength, temperature,
features, and active connection time.
iv. When charging, keep your Gateway near room temperature.
v. Never leave the Gateway in an unattended vehicle due to
uncontrolled temperatures that may be outside the desired
temperatures for your Gateway.
vi. It is normal for batteries to gradually wear down and require longer
charging time.
2. Place it on an elevated surface near a window.
3. Wait up to 15 minutes for the system light to turn off.
The light will blink white while the Gateway is powering on and
updating software. Don’t turn off the power to the Gateway.
If it turns solid red: No signal in this location. Move the Gateway to
another location.
If it blinks red: Activation error. Power off the Gateway and turn it back
on.
To Next Page
Loading...
