NETWORK SETTINGS
WAN IPv6 with LAN IPv6 Stateless Settings
1. To configure IPv6 LAN Stateless mode with DHCPv6 WAN, select the
Stateless option on the IPv6 Configuration Controls page.
2. Specify the settings to be used to assign LAN IPv6 addresses by
entering the following details:
• IPv6 LAN Configuration (select Stateless from the dropdown list)
• LAN Prefix (automatically populated)
• LAN Link Local Address (automatically populated)
• Subnet ID - set the site topology for your internal site
• Router Advertisement Lifetime (minutes between 0-150)
• Option: Allow ICMPv6 Echo Request for LAN devices using their
Global IPv6 Address from WAN side - requesting an IPv6 address
from any available DHCPv6 servers available on the ISP
3. After entering all appropriate IPv6 settings, click Apply changes to have
changes take effect.
To Next Page
Loading...
