About the Edge 5000 1-3
Chapter 1: Introducing the IP5000
Edge 5000 Installation / Configuration Guide
IP5000
Number Function
1 Left button - When appears in the bottom-left corner of the LCD, the previous
menu may be selected with the left navigation button.
Right button - When appears in the bottom-right corner of the LCD, the next
group of softkeys may be selected with the right navigation button.
Up button - When the phone is in the idle state, accesses the call log.
Down button - When the phone is in the idle state, accesses the phonebook.
2 OK - Select a current item or save a value in the settings menu.
3 Softkeys - Softkeys are interactive, changing function based on the IP Phone
status.
4 Flexible buttons with Red/Green LEDs - Assign as Line or feature in Phone
configuration. Default assignments for buttons 1 and 2 are primary and secondary
Line appearance for the extension. IP5000 has 24-flexible buttons.
5 Settings button - ‘Settings’ accesses and exits the menu for display and changes
to the IP Phone configuration.
6 DND (Do-Not-Disturb) button - Use to activate DND so that extension will not
ring.
7 Headset button - When using a headset, this button toggles the headset state.
When the headset is active, the button LED illuminates red.
8 Volume control button - Use to adjust Ring, Headset, Handset, and Speaker
volume.
9 Message button - When the Message LED indicates you have a message use to
access Voice Mail server.
10 Transfer button - Use to transfer the current active call.
11 Hold button - Use to place a call on Hold. Also, use to access a held call.
12 Mute button - Toggle audio from the microphone to the connected party On and
Off.
13 Speakerphone button - Toggle the IP phone speakerphone On and Off.
14 Dial pad buttons - Use to dial a number, select a menu item, or input a value.
To Next Page
Loading...
