Lock Outgoing Call 3-42
Chapter 3: Using the LCD Configuration Menu
Edge 5000 Installation / Configuration Guide
Lock Outgoing Call
The IP Phone can be configured to allow outgoing calls only if a password is entered. When
enabled, the LCD screen will display the password request and the password must be entered
prior to connecting for outgoing call.
To activate this feature, the LCD password must be set, refer to "Lock/Unlock Configuration" on
page 3-4 and Lock Outgoing Call must be enabled.
To enable/disable the Lock Outgoing Call feature:
• Press the Settings ( ) button. If the LCD Menu is locked, use the unlock
procedure. Refer to
page 3-4.
• Press the digit, or move the cursor to 3.Phone Settings using the
[Next]-[Previous] softkeys and press the [OK] softkey.
• Press the digit, or move cursor to 8.Lock Outgoing Call using the
[Next]-[Previous] softkeys and press the [OK] softkey.
• Press the [Yes] softkey to enable the Lock Outgoing Call, or press the [No] softkey to
disable the Lock Outgoing Call.
• Move to another parameter with the navigation buttons and continue the session or
press the Settings ( ) button to exit the configuration session.
Speed Number
Each IP5000 series phone includes a Phone Book that supports up to 100 entries. Each Phone
Book record includes a two (2) digit Speed number, see
“Phone Book” on page 50. When
enabled, dialing the Speed Number (00-99) sends the contact information from the associated
Phone Book record.
To enable/disable Speed Number operation:
• Press the Settings ( ) button.
• Press the digit, or move the cursor to 3.Phone Settings using the
[Next]-[Previous] softkeys and press the [OK] softkey.
• Press the digit, or move the cursor to 9.Speed Number using the
[Next]-[Previous] softkeys and press the [OK] softkey.
• Press the [Yes] softkey to enable the Speed Number, or press the [No] softkey to
disable the Speed Number.
• Move to another parameter with the navigation buttons and continue the session or
press the Settings ( ) button to exit the configuration session.
When enabled, dialing an empty Speed Number terminates the call and the empty status of the
Speed Number displays for approximately 2 seconds.
To Next Page
Loading...
