Reboot 3-55
Chapter 3: Using the LCD Configuration Menu
Edge 5000 Installation / Configuration Guide
NOTE: Returning the configuration to default requires a reboot of the IP Phone; when you leave the
menu, you will receive a reboot notice. The IP Phone must reboot to utilize the new values
entered.
Returning the IP Phone to the default configuration deletes all previous customized settings.
Reboot
After changing certain parameters, the IP Phone will require a reboot to utilize the settings.
These settings include the following:
- Network Configuration settings
- Call Server Address settings
- Software Update settings
- Default settings
To reboot the IP Phone:
• Press the Settings ( ) button. If the LCD Menu is locked, use the unlock
procedure. Refer to
page 3-4.
• Press the digit, or move the cursor to 9.Reboot using the [Next]-[Previous]
softkeys, and press the [OK] softkey.
• Press the [Yes] softkey to reboot the IP Phone, or press the [No] softkey to cancel this
menu.
• If you press [No] in the above step, move to another parameter with the navigation
buttons and continue the session or press the Settings ( ) button to exit the
configuration session without activating the changes. Any parameter changes will
update during the next reboot.
To Next Page
Loading...
