Call Hold Ringback 3-48
Chapter 3: Using the LCD Configuration Menu
Edge 5000 Installation / Configuration Guide
• Move to another parameter with the navigation buttons and continue the session or
press the Settings ( ) button to exit the configuration session.
Call Hold Ringback
With Call Hold Ringback enabled, the IP Phone rings as a reminder of calls on hold when the
user returns the IP Phone to idle.
To enable/disable Call Hold Ringback:
• Press the Settings ( ) button. If the LCD Menu is locked, use the unlock
procedure. Refer to
page 3-4.
• Press the digit, or move the cursor to 4.Call Preferences using the
[Next]-[Previous] softkeys and press the [OK] softkey.
• Press the digit, or move the cursor to 4.Call Hold Ringback using the
Next]-[Previous] softkeys and press the [OK] softkey.
• Press the [Yes] softkey to enable hold ringback, or press the [No] softkey to disable
hold ringback.
• Move to another parameter with the navigation buttons and continue the session or
press the Settings ( ) button to exit the configuration session.
Message Waiting Tone
When notification of a new message is received, the Message LED flashes. As an option, a
'stutter' dial tone provides an audible indication for a message waiting. When the user goes
off-hook to place a call, the user receives stutter dial tone.
To enable/disable stutter dial tone for a message wait indication:
• Press the Settings ( ) button. If the LCD Menu is locked, use the unlock
procedure. Refer to
page 3-4.
• Press the digit, or move the cursor to 4.Call Preferences using the
[Next]-[Previous] softkeys and press the [OK] softkey.
• Press the digit, or move the cursor to 5.Msg Waiting Tone using the
[Next]-[Previous] softkeys and press the [OK] softkey.
• Press the [Yes] softkey to enable stutter dial tone, or press the [No] softkey to disable
stutter dial tone.
• Move to another parameter with the navigation buttons and continue the session or
press the Settings ( ) button to exit the configuration session.
To Next Page
Loading...
