SIP Configuration, Line Parameters 3-20
Chapter 3: Using the LCD Configuration Menu
Edge 5000 Installation / Configuration Guide
• Select the type for the line using the [Next]-[Previous] softkeys and press the [OK]
softkey to save your entry.
• Move to another parameter with the navigation buttons and continue the session or
press the Settings ( ) button to exit the configuration session.
NOTE: Changing the Line Type requires a reboot of the IP Phone; when you leave the menu, you will
receive a Reboot notice. The IP Phone must reboot to utilize the new values entered.
An asterisk,
@, is displayed in front of the current selection.
Extension for DSS Line
A DSS Line requires entry of the associated extension number. Note do not assign a DSS
extension number for a private or shared line type.
To assign an extension number for a DSS line,
• Press the Settings ( ) button. If the LCD Menu is locked, use the unlock
procedure. Refer to
page 3-4.
• Press the digit, or move the cursor to 2.SIP Configuration using the
[Next]-[Previous] softkeys and press the [OK] softkey.
• Press the digit, or move the cursor to 1.Line Configuration using the
[Next]-[Previous] softkeys and press the [OK] softkey.
• Enter the line button number or move the cursor using the [Next]-[Previous] softkeys
and press the [OK] softkey to select a line button.
• Press the digit, or move the cursor to 9.Extension for DSS using [Next]-[Previous]
softkeys and press the [OK] softkey.
• Input the extension number for the DSS line using the dial pad and press the [OK]
softkey to save your entry.
• Move to another parameter with the navigation buttons and continue the session or
press the Settings ( ) button to exit the configuration session.
NOTE: Assign an extension number only for a DSS line. Do not assign an extension number for a private
or shared line.
To Next Page
Loading...
