SIP Configuration, General Parameters 3-22
Chapter 3: Using the LCD Configuration Menu
Edge 5000 Installation / Configuration Guide
• Input the Outbound Proxy Port using the dial pad and press the [OK] softkey to save
your entry.
• Move to another parameter with the navigation buttons and continue the session or
press the Settings ( ) button to exit the configuration session.
NOTE: Changing the Outbound Proxy Port requires a reboot of the IP Phone; when you leave the menu,
you will receive a reboot notice. The IP Phone must reboot to utilize the new values entered.
Backup Proxy Address
When employing an outbound proxy, a backup proxy can be defined for use should the primary
proxy fail to respond. The Backup Proxy Address is an IP address or a FQDN.
To assign a Backup Proxy Address:
• Press the Settings ( ) button. If the LCD Menu is locked, use the unlock
procedure. Refer to
page 3-4.
• Press the digit, or move the cursor to 2.SIP Configuration using the
[Next]-[Previous] softkeys and press the [OK] softkey.
• Press the digit, or move the cursor to 4.Backup Proxy Address using the
[Next]-[Previous] softkeys and press the [OK] softkey.
• Input the Backup Proxy Address using the dial pad and press the [OK] softkey to save
your entry.
• Move to another parameter with the navigation buttons and continue the session or
press the Settings ( ) button to exit the configuration session.
NOTE: Changing the Backup Proxy Address requires a reboot of the IP Phone; when you leave the
menu, you will receive a reboot notice. The IP Phone must reboot to utilize the new values
entered.
To enter alphanumeric characters select the [Mode] softkey. Refer to Appendix E for the
character mapping of dial pad digits.
To Next Page
Loading...
