SIP Configuration, General Parameters 3-26
Chapter 3: Using the LCD Configuration Menu
Edge 5000 Installation / Configuration Guide
Domain
The Domain specifies the domain for SIP service when the provider desires to use a specific
SIP domain for the IP Phone.
To assign the Domain
• Press the Settings ( ) button. If the LCD Menu is locked, use the unlock
procedure. Refer to
page 3-4.
• Press the digit, or move the cursor to 2.SIP Configuration using the
[Next]-[Previous] softkeys and press the [OK] softkey.
• Press the digits , or move the cursor to 11.Domain using the [Next]-[Previous]
softkeys and press the [OK] softkey.
• Input the Domain name using the dial pad and press the [OK] softkey to save your
entry.
• Move to another parameter with the navigation buttons and continue the session or
press the Settings ( ) button to exit the configuration session.
NOTE: To enter alphanumeric characters select the [Mode] softkey. Refer to Appendix E for the
character mapping of dial pad digits.
STUN Server
When the phone is located behind NAT and a STUN server exists, this menu sets the STUN
server IP address or FQDN.
To assign the STUN server
• Press the Settings ( ) button. If the LCD Menu is locked, use the unlock
procedure. Refer to
page 3-4.
• Press the digit, or move the cursor to 2.SIP Configuration using the
[Next]-[Previous] softkeys and press the [OK] softkey.
• Press the digits , or move the cursor to 12.Stun Server using the
[Next]-[Previous] softkeys and press the [OK] softkey.
• Input the Stun Server using the dial pad and press the [OK] softkey to save your entry.
• Move to another parameter with the navigation buttons and continue the session or
press the Settings ( ) button to exit the configuration session.To enter
alphanumeric characters select the [Mode] softkey. Refer to Appendix E for the
character mapping of dial pad digits.
To Next Page
Loading...
