S/W Update 3-37
Chapter 3: Using the LCD Configuration Menu
Edge 5000 Installation / Configuration Guide
• Press the digit, or move the cursor to 3.HTTPS Provisioning using the
[Next]-[Previous] softkeys and press the [OK] softkey.
• Press the digit, or move the cursor to 1.Provisioning URL using the
[Next]-[Previous] softkeys and press the [OK] softkey.
• Input the provisioning server URL using the dial pad and press the [OK] softkey to
save the entry.
• Move to another parameter with the navigation buttons and continue the session or
press the Settings ( ) button to exit the configuration session.
NOTE: Changing the provisioning server URL requires a reboot of the IP Phone; when you
leave the menu, you will receive a reboot notice. The IP Phone must reboot to
utilize the new values entered.
To enter alphanumeric characters select the [Mode] softkey. Refer to Appendix E
for the character mapping of dial pad digits.
Username
In some cases, the HTTP/HTTPS server requires a Username (Id) and Password for
authentication prior to allowing file access.
To set the Username:
• Press the Settings ( ) button. If the LCD Menu is locked, use the unlock
procedure. Refer to
page 3-4.
• Press the digit, or move the cursor to 3.Phone Settings using the
[Next]-[Previous] softkeys and press the [OK] softkey.
• Press the digit, or move the cursor to 7.S/W Update using the [Next]-[Previous]
softkeys and press the [OK] softkey.
• Press the digit, or move the cursor to 3.HTTPS Provisioning using the
[Next]-[Previous] softkeys and press the [OK] softkey.
• Press the digit, or move the cursor to 2.Username using the [Next]-[Previous]
softkeys and press the [OK] softkey.
• Input the Username using the dial pad, and press the [OK] softkey to save your entry.
• Move to another parameter with the navigation buttons and continue the session or
press the Settings ( ) button to exit the configuration session.
NOTE: Changing the Username requires a reboot of the IP Phone; when you leave the
menu, you will receive a reboot notice. The IP Phone must reboot to utilize the new
values entered.
To enter alphanumeric characters select the [Mode] softkey. Refer to Appendix E
for the character mapping of dial pad digits.
To Next Page
Loading...
