Call Preferences 4-10
Chapter 4: Using Web Manager for Configuration
Edge 5000 Installation / Configuration Guide
• Call Waiting Tone, when the IP Phone is in use with call waiting enabled, a beep
tone delivered over the existing call indicates an incoming call.
• Call Hold Ringback
, when enabled, rings the phone if the user returns to idle with
a call on hold.
• Message Waiting Tone
, when enabled, stutter dial tone notifies the user a new
message is waiting. Stutter dial tone notification is in addition to the visual
flashing Message LED notification.
• Auto Answer
, when enabled, will activate the speakerphone or headset
automatically if an incoming call is received.
- Call Forwarding
• Conditions
define the condition for Call Forward (Busy, No-Answer, Busy &
No-Answer, unconditional, or not used).
• Address to Forward
defines the destination to receive forwarded calls.
• No-Answer Time
sets the delay for no-answer forward.
- Direct Call (Hotline/Warm-Line)
• Direct Call
, when enabled, places a call to a predefined destination automatically
when the phone goes off hook.
• Direct Call Number
defines the destination for a direct call.
• Direct Call Timer
sets a delay timer for Warm-Line operation. The timer specifies
the period before placing a direct call. The timer is set in 1 second increments
from zero (0) to ten (10) seconds. For Hotline operation, set the timer to zero (0)
seconds.
To modify parameters on the Call Preferences screen:
• Select the desired parameter and enter new values, or select values from the
drop-dow menus.
• When complete, select the button to load new values to the IP Phone
memory.
To Next Page
Loading...
