UPFLOW MODELS CW106 & CW114 LOW VOLTAGE
ELECTRICAL FIELD CONNECTIONS
LIEBERT CW
Form No.: DPN001040_REV4
REV : 0
REV DATE : 2/18
DPN004551
Page :2 /2
Monitoring panel.
Disconnect Switch
Remove knockouts
to access
control board.
Electric Box Bottom
Unit Bottom
Bottom Entrance
Low Voltage Communication Wiring
CAT5E Ethernet connections – field installed
Avoid routing near high voltage wiring.
Secure wiring to prevent damage and
use bushing or edge guard to avoid sharp edges.
Remove knockout
1
1
1. To provide unit to unit (U2U) networking, the customer
must first connect an Ethernet cable from P64
on the iCOM control board, to a network switch.
Notes:
P64
Top Entrance
NOTE: Refer to specification sheet for full load amp and wire size amp ratings.
To Next Page
Loading...
Need help?
General