3.10 Setting unit name, location and serial number
When logged-in as an Advanced user, you can see a list of managed units and their enabled/disabled
status. You can also set the unit’s name (displayed in the web UI), location, and serial number.
1. On the menu bar, click ADVANCED, and select a unit in the ADVANCED SETTINGS panel.
2. Enter the unit information in the secondary, properties panel, and click Save.
Advanced property fields
Unit Name
Descriptive name of the cooling unit displayed in mobile application and on the Admin Portal.
Unit Location
Descriptive location information for the cooling unit displayed in the web-based UI.
Unit Type
The Liebert® model of the cooling unit. See Setting the Managing Mode on page 32, to change the
unit type monitored by iCOMCMS.
Serial number
Serial number of the cooling unit.
Port
Communication port of the cooling unit.
Device Address
Address corresponding to the Modbus gateway board.
3.11 Setting the iCOMCMS Name
When logged-in as an Advanced user, you can update the name of the iCOMCMS displayed at the top of
the web-based interface and passed to the cloud for display as the tab heading on the mobile application.
1. On the menu bar, click SETTINGS, then iCOM-CMS Name in the settings list.
The iCOM-CMS panel displays.
2. Enter a a name and click Save.
• Click Cancel to discard the changes.
3 Service and Advanced Operation
31