23
Vertiv I Liebert LPC I User Manual
Figure 2-4 Fixing bolt on the base pallet
2.1.3 Unpacking for Wooden Packaging
If a wooden packaging is used instead of paper packaging, the process is slightly different.
The following process Is to be adhered if a wooden packaging is used. For export, a wooden
packaging is used and the process is slightly different from the process followed in section
2.12.
The Transportation mode is preferably via Railroad or shipping; however, there are times
when truck transportation is mandatory for some locations. In such cases, chose roads that
are not bumpy to ascertain that there is no damage to the equipment. It is highly
recommended that an electric forklift is used to unload and move the product enclosed in
the wooden packaging.
Refer to the Figure 2-5 to understand the process better:
Figure 2-5 Transportation for export Wooden-packaged LPC systems
In Figure 2-5, the tines of the forklift are inserted below the pallet. This is done to ensure
that the equipment does not fall over leading to injury to the personnel or damage to the
equipment.
To Next Page
Loading...
Need help?
General
