32
Vertiv I Liebert LPC I User Manual
Table 2.3
Models A B C
2.6.4 Side panel Knock-out locations
If there is difficulty in the piping and wiring process from the base, then an alternative option
would be a connection from the side panel. The locations and dimensions of the knock-out
holes are depicted in Figure 2-17.
The outlet and inlet holes should be selected based on the actual needs.
Remember the rule that only one service is used per opening.
P Power Cable Inlet/Outl
et | C/R Cooling water/ Refrigerant inlet and outlet pipe holes
H Hole for incoming water pipe of the humidifier
D Hole for Drain pipe
Figure 2-17 Side panel Knockout connection
The equipment has knock-outs, be sure to mount the sleeve to the cable holes
to avoid cutting the cables.
To Next Page
Loading...
