Videotek VTM-2000 - Blanking (SD-SDI Only); Center Waveform; Component Sequence (SD-SDI Only); Format

General Operation
VTM-2000 Installation and Operation Handbook
3-16
Format
When in the Format menu, select one of the display formats: RGB, YRGB, or YC
B
C
R
.
The selected RGB, YRGB, or YC
B
C
R
text is indicated with a check mark.
Blanking (SD-SDI only)
The blanking selections are Blank All, SAV/EAV, and Show All.
• “Blank All” displays only the active video of the input signal.
• “Show SAV/EAV” displays the active video and the SAV/EAV headers of the
input signal.
• “Show All” displays the ancillary data, SAV/EAV, and active video.
Component Sequence (SD-SDI only)
Select to enable the component Y, C
B
, and C
R
when YC
B
C
R
is used, Y, R, G, and B,
when YRGB is used, or R, G, and B when RGB is used.
Center Waveform
Press the SETUP/ENTER button to activate the Center Waveform selection. Once
SETUP/ENTER is pressed, the waveform returns to the center of the waveform
graticule.
Waveform Setup
Press the SETUP/ENTER button to access the global Waveform setup menu. For more
information on the global Waveform Setup menu see Section 4.