Preset positions
1. To store a preset position
Move the camera to the required position then press the record key followed
by the number key of the preset to be stored (1 – 9)
Dependant on Dome or protocol you may then have to enter a password or exit from
menus.
PowerDome PRO – use the Down arrow to move to the Enter command then the
Right arrow to accept
VPDL6 – Navigate up, down, left and right in “Pan / Tilt Mode”
Enter key is Right arrow in “Zoom /Focus Mode”
2. To recall a Preset
Press the search key followed by the number (1 -9).
Run Tour 1
To run Tour 1, press the search key followed by the number 0 (Zero). The tour
requires a keyboard to set it up in the domes menu.
To Next Page
Loading...
