S83068
S83070
ii'IW
Operating instructions
98
Safety and responsibility
Never approach a high voltage wire
You can receive an electric shock if the machine approaches close
to a high tension power line. Physical contact is not necessary to
draw current from the power line!
If working near a high tension power line, prohibit everyone from
approaching the machine.
Contact the electricity supply company prior to working near over-
head power lines.
For safety reasons, maintain the following minimum distance be-
tween the machine and the power line.
Voltage
Mm.
clearance from electric line
0-1KV
2m(7ft.)
1-55KV
4m(l3ft.)
55-500KV
6m(20ft.)
If the attachment comes into contact with the power line, stay in the
cab, and if the machine remains functional, try to break the circuit
by moving the attachment away from the power line.
Permissible depth of water
WARNING!
When traveling out of water, If the rear of the upper body is
under water, the engine fan may be damaged. Be careful in
this situation.
Permissible working depth in water is the center of upper rollers.
Do not fully submerge the upper rollers.
Upon leaving the water, make sure all the grease is replenished in
the areas affected by the water, e.g. bucket pin etc., remove the
old grease completely regardless of the maintenance period.
Also check the oil in the travel drive for contamination, and if nec-
essary, replace it.
1
Upper roller
2 Water level
To Next Page
Loading...
