Using the WebUI 76 Back to Contents
VCS752 Administrator and Provisioning Manual
Setting Description
Mode Sets which files for which the VCS752 checks. It can check
for configuration files, firmware update files (from the URL
entered on the Firmware Server Settings page), or both.
Note: When checking for both configuration and firmware
files, the firmware URL can be within the config file. This
firmware URL takes take precedence over the URL on the
Firmware Server Settings page. It will also update the URL
on the Firmware Server Settings page. This allows you to
change the firmware URL automatically.
Bootup Check Sets the VCS752 to check the provisioning URL for new
configuration and/or firmware files upon bootup. The
update is applied as part of the reboot process.
Schedule Check: Disable
When selected, disables regularly scheduled file checking.
Schedule Check: Interval
Sets an interval for checking for updates. After selecting
Interval, enter the interval in minutes between update
checks.
Schedule Check:
Days of the Week
Select to enable weekly checking for updates on one or
more days. After selecting Days of the Week, select the
day(s) on which the VCS752 checks for updates.
Start Hour
Select the hour of the day on which the VCS752 checks for
updates.
End Hour
Select the hour of the day on which the VCS752 stops
checking for updates.
Use encryption Enables an AES-encrypted configuration file to be
decrypted before being applied to the VCS752. Select if
the configuration file has been secured using AES
encryption. See “Securing configuration files with AES
encryption” on page 90.
Passphrase If the configuration file has been secured using AES
encryption, enter the 16-bit key. See “Securing
configuration files with AES encryption” on page 90.
To Next Page
Loading...
