2-8 OM 803 us – Edition 3.7 * * 803b210us.fm
Safety instructions
2.8 Operator Protection System
TOPS rollbar (up to serial no. AF01416)
ROPS rollbar
The machine can be equipped with an optional lowerable TOPS or ROPS rollbar.
Personal injury hazard! In order to ensure the best possible
protection for the operator, operate the machine only with a
raised rollbar.
Causes severe personal injury or death.
• Always fasten the seat belt if the rollbar is raised.
Personal injury hazard! Do not modify the rollbar.
Failure to follow this precautionary measure can lead to severe injury or death.
• No drilling, cutting or grinding.
• No welding, straightening or bending.
• Do not mount any brackets.
• Repair work may be performed by a Wacker Neuson dealer only.
• Always replace the complete rollbar if it is deformed, cracked or otherwise
damaged.
• If you are not sure, always contact a Wacker Neuson dealer.
Traveling without TOPS rollbar (up to serial no. AF01416)
Traveling without ROPS rollbar
Accident hazard! Do not operate the machine with a lowered
rollbar.
Failure to follow this precautionary measure will cause severe injury or death.
• Traveling with a lowered rollbar is temporarily allowed depending on the situa-
tion (e.g. to reduce the transport height in case of low clearance heights) – but
only if the following conditions are fulfilled:
• Obtain the approval of the competent national authority.
• Machine travel is only allowed on absolutely level ground.
• Avoid tipping movements of the machine under all circumstances.
• Fastening the seat belt is prohibited.
• Wear protective equipment (e.g. protective clothing, safety glasses).
To Next Page
Loading...
Need help?
General
