3-32 OM 803 us – Edition 3.7 * * 803b330.fm
Operation
3.10 Lowerable ROPS rollbar (up to serial no. AI00966) (option)
Accident hazard when operating the machine with a lowered
rollbar!
Can cause serious injury or death.
• Machine operation is only allowed if the rollbar is raised and locked, and if
the seat belt is fastened.
• Depending on the situation, traveling over very short distances with a low-
ered rollbar is allowed (in case of low clearance heights, for example) – see
chapter Operation with lowered ROPS rollbar on page 2-9.
Injury hazard due to unfastened seat belt!
Can cause serious injury or death.
• Use the seat belt only if the rollbar is raised!
Injury hazard due to damaged rollbar!
Can cause serious injury or death.
• Machine operation with a damaged rollbar is prohibited. Contact a Wacker
Neuson service center.
The boom must not be moved if the rollbar is lowered!
Bracket P for installing a rotating beacon is located on top of the rollbar.
Lowering the rollbar
☞Stop the machine on firm, level and horizontal ground
☞Stop the engine
☞Raise the lock lever
☞Remove the starting key
In order to lower it, the rollbar must be held by one person on either side.
☞Remove the lock nuts and screws A on either side
☞Slowly and carefully lower the rollbar
☞Insert the screws again on either side and secure them with the lock nuts
Fig. 85: Lowerable ROPS rollbar (option)
B
C
A
P
S
D
To Next Page
Loading...
