WAGO SYSTEM 750 - Removing the I;O Module; Figure 10: Removing the I;O Module (Example)

WAGO-I/O-SYSTEM 750 Mounting 49
750-493 3-Phase Power Measurement Module
Manual
Version 1.2.0
Pos: 73.1 0 / Seri e 7 50 ( WAG O-I/ O-SYST EM)/ Monti eren/D emo ntiere n/Bus klem me entfer nen @ 4\ mod_1239169375203_21. docx @ 30334 @ 3 @ 1
6.2.2 Removing the I/O Module
1. Remove the I/O module from the assembly by pulling the release tab.
Figure 10: Removing the I/O Module (Example)
Electrical connections for data or power jumper contacts are disconnected when
removing the I/O module.
Pos: 74 /Dokum entat ion all gemei n/Gli eder ungsel eme nte/---Seit en wechs el--- @ 3\mod_1221108045078_0.docx @ 21810 @ @ 1