66 Commissioning WAGO-I/O-SYSTEM 750
750-493 3-Phase Power Measurement Module
Manual
Version 1.2.0
8.1.5 "Factory Settings" Tab
After entering a password (see "Energy" tab above), you can reset all parameters
of the I/O module to their factory settings on the "Factory Settings" tab.
Use I/O Module Settings [Restore] to reset the I/O module settings only.
Calibration data remains unchanged.
Use Calibration Data [Restore] to reset the calibration data only. The I/O module
settings remain unchanged.
Use Total [Restore] to reset all I/O module settings and calibration data.
These actions are carried out immediately and cannot be undone. Therefore, the
[Save] button is disabled at the bottom of the window.
Figure 22: "Factory Settings" Tab
Pos: 89 /Dokum entat ion all gemei n/Gli eder ungsel eme nte/---Seit en wechs el--- @ 3\mod_1221108045078_0.docx @ 21810 @ @ 1
To Next Page
Loading...
