WAGO-I/O-SYSTEM 750 Commissioning 57
750-493 3-Phase Power Measurement Module
Manual
Version 1.2.0
Pos: 87 /Al l e Ser ien (Al lg emei ne M od ule)/Ü b ersc hrif te n für all e S eri en/I nbetr i ebn ehm en - K onfig uri eren - Par amet ri eren - Bedienen/In Betrieb nehmen - Übersc hrif t 1 @ 4\ mod_1240901452750_21.docx @ 31570 @ 1 @ 1
8 Commissioning
Pos: 88 /S eri e 7 50 ( WA GO-I/O-S YSTEM )/In B etrie b nehm en/Par ametr ieren mit WAGO- I/O-C HECK /Para metri eren mi t WAGO -I/O-CHECK 750-049 3 @ 13\ mod_1355128769520_21.docx @ 107450 @ 233333 @ 1
The I/O module latched in the bus node and wired for the measurement can be put
into operation using the WAGO-I/O-CHECK software for Windows. For that, the
fieldbus coupler/controller of the node is connected, for example, to the USB port
of a PC using the WAGO USB communication cable.
WAGO-I/O-CHECK provides the following functions:
• Graphic display of the bus node
• Display of the process data (measured values)
• Application settings
• Settings for the measurements for each of the three phases
• I/O module settings
• Settings for saving the energy values
WAGO-I/O-CHECK
You can obtain the WAGO-I/O-CHECK software on a CD under Item No. 759-
302. This CD contains all the application program files and a description.
The description is also available in the Internet at http://www.wago.com under
Documentation > WAGO Software > WAGO-I/O-CHECK.
To display the bus node on the PC, use the USB communication cable to connect
coupler/controller and PC and launch WAGO-I/O-CHECK.
To Next Page
Loading...
