WAGO SYSTEM 750 - Displaying the Measured Values Via WAGO-I;O-CHECK; Figure 23: Measured Values, Overview

70 Commissioning WAGO-I/O-SYSTEM 750
750-493 3-Phase Power Measurement Module
Manual
Version 1.2.0
Pos: 92 /Al l e Ser ien (Al lg emei ne M od ule)/Ü b ersc hrif te n für all e S eri en/ __ n och ni cht ei ns ortier te Ü b ersc hrif te n m üssen noc h eins orti ert wer den __/ Anz eig en der M es swert e mit WAG O-I/O-CH ECK - Ü b erschr if t 2 @ 13\ mod_1355494395030_21.docx @ 107680 @ 2 @ 1
8.2 Displaying the Measured Values via WAGO-I/O-
CHECK
Pos: 93 /S eri e 7 50 ( WA GO-I/O- SYST EM) /I n B etrie b ne hm en/A nzei g en d er Me ss wer te mi t WA GO-I /O-CH ECK 75 0-049 3 @ 16\mo d_1372771300798_21.docx @ 125355 @ @ 1
The measured values are displayed in the "3-phase power measurement" dialog in
several views.
The Overview view displays the measured values of all three phases
continuously. These are:
• Current, voltage Lx-N, active power, cos phi and frequency.
An undervoltage is identified as a red square.
Change of the Measuring Units!
Specify the prefixes of the measuring units by selecting Home > Settings >
Application. See section "Configuration with WAGO-I/O-CHECK" >
"Application" Tab.
The units can only be changed in the lists with the same physical variables. For
lists with different variables, base units are always used!
Figure 23: Measured Values, Overview