WAGO SYSTEM 750 - Current Measurement; Current Measurement on a Motor; Figure 13: Current Measurement on a Motor

52 Connect Devices WAGO-I/O-SYSTEM 750
750-493 3-Phase Power Measurement Module
Manual
Version 1.2.0
Pos: 81 /Al l e Ser ien (Al lg emei ne M od ule)/Ü b ersc hrif te n für all e S eri en/ __ n och ni cht ei ns ortier te Ü b ersc hrif te n m üssen noc h eins orti ert wer den __/Strommessung - Übersc hrif t 2 @ 13\mod_1346248472189_21.docx @ 102101 @ 2 @ 1
7.3 Current Measurement
Pos: 82 /S eri e 7 50 ( WA GO-I/O-SYST EM) /Ans chl i eßen/ An schl uss bei spi ele/ Anal og eing angs kl em men/ Str ommes su ng 7 50-0 493 @ 16 \mod_1372769974422_21.docx @ 125339 @ 3344443 @ 1
7.3.1 Current Measurement on a Motor
For measuring the currents of a 3 phase electrical motor connect it with the CAGE
CLAMPS
®
IL1, IL2, IL3 and IN via current transformers.
Connect CAGE CLAMP
®
N to earth, if not connected to the neutral wire!
If you do not connect the CAGE CLAMP
®
N with the neutral wire of the supply
network (e.g. using the module for pure current measurement) you must connect
N to earth PE to avoid hazardous voltages in the event of faults!
Figure 13: Current Measurement on a Motor