WAGO-I/O-SYSTEM 750 Commissioning 61
750-493 3-Phase Power Measurement Module
Manual
Version 1.2.0
8.1.1 "Application" Tab
Make application settings in the "Application" tab. These settings are not stored in
the I/O module, but on the connected PC.
You specify again the decimal multiples for displaying the measuring units for the
various measured variables or keep them:
10
-3
=milli or 10
0
=1 or 10
3
=kilo.
In addition, you specify the storage path for the measured value records. See
"Measurement Recording" in the following section "Displaying the Measured
Values via WAGO-I/O-CHECK".
Figure 18: "Application" Tab
To Next Page
Loading...
