WAGO-I/O-SYSTEM 750 Commissioning 65
750-493 3-Phase Power Measurement Module
Manual
Version 1.2.0
8.1.4 "Energy" Tab
After entering a password, you can set or reset the energy values per phase on the
"Energy" tab. The initial password is: wago. Please change this password on first
use by clicking [Change password].
The energy values are saved automatically every 15 minutes. Use the [Save] and
[Delete] commands to save the actual value or set it to 0. These actions are carried
out immediately and cannot be undone. Therefore, the [Save] button is disabled
at the bottom of the window.
Figure 21: "Energy" Tab
To Next Page
Loading...
