WAGO SYSTEM 750 - Figure 29: Measured Values, Recording

76 Commissioning WAGO-I/O-SYSTEM 750
750-493 3-Phase Power Measurement Module
Manual
Version 1.2.0
On the Measurement Recording view, 3 measured variables are represented in
chronological sequence. You can select the measured variables you want to see in
the 3 drop-down lists.
Figure 29: Measured Values, Recording
In general, you can select in the 3 waveforms whether:
• The samples are displayed over a certain period of time (with ).
or
• A certain number of samples is displayed (with ).
You can then enter the duration by start and end time or the number of samples. In
both cases, the measurement interval, i.e. sample rate, can also be selected from
250 to 300,000 ms.
Clicking the arrow, the [Start] button generates a drop-down list in which you can
select "No Export". By doing this, no export CSV file is generated.
If you click [Start] as usual, a "Save" window opens in which you can specify the
storage location for the CSV file. After you have specified the storage location the
measurement starts. Use [Stop] to stop the measurement prematurely. For
examples of CSV files, see section "Appendix".
Use the mouse wheel to zoom in and out within the three graphic waveforms.
Hold down the left mouse button to move the displayed range.
Click again to follow the current waveform.
Pos: 94 /Dokum entat ion all gemei n/Gli eder ungsel eme nte/---Seit en wechs el--- @ 3\mod_1221108045078_0.docx @ 21810 @ @ 1