WAGO SYSTEM 750 - Figure 16: 3-Phase Power Measurement Dialog

WAGO-I/O-SYSTEM 750 Commissioning 59
750-493 3-Phase Power Measurement Module
Manual
Version 1.2.0
Figure 16: "3-Phase Power Measurement" Dialog
The following buttons appear in the Home (1) ribbon:
[Disconnect]
Separates the fieldbus coupler/controller from the PC
[Snapshot]
Opens a "Save as" dialog to save all current measured
values and I/O module settings as a CSV file. In this
dialog, enter a file name and select a location to save the
file, e.g. see section "Appendix".
[Settings]
Opens the settings dialog.
[Calibration]
Opens the calibration dialog. More information is
available from the WAGO Support.
The buttons for the individual measured value views appear in the menu (2).
The status bar (3) displays the connection icon and IP address of the fieldbus
coupler/controller or the name of the COM port.
Click [Settings] to open the "Settings" dialog in which you can configure the
application and I/O module.