Waters 996 - Millennium Workstation Connections; Connecting the IEEE-488 Cable; Detector Rear Panel

16 Installation
1
Connecting the Power Cord
Connect one end of the 996 detector power cord to the rear panel power receptacle
(Figure 1-2
) and the other end to a power outlet.
Figure 1-2 Detector Rear Panel
1.3 Millennium
32
Workstation Connections
The 996 detector requires signal connections to the Millennium
32
Workstation over the
IEEE-488 bus. All detector control and data acquisition communications take place over
the IEEE-488 bus.
Note:
If an inject start signal is not available over the IEEE-488 bus, you must provide a
signal at the Event In terminals on the 996 detector rear panel (see Section 1.4.2,
Connecting Event Cables).
1.3.1 Connecting the IEEE-488 Cable
Note:
If the 996 detector is to be rack-mounted or stacked on other instruments, use the
right-angle adaptor included in the Startup Kit when you make the IEEE-488 connection.
TP01452
Power Cord
Receptacle