WBOX Technologies 0E-4CHNVR2TB - Page 73

Setting
Network Video Recorder(NVR)
User Manual
Issue V1.0 (2018-05-11)
65
Figure 8-26 The PPPoE interface
Step 2 Click the button on to enable PPPoE. Set the parameters according to Table 8-8.
Table 8-8 PPPoE parameters
Parameter
Description
Setting
PPPoE
Indicates whether to enable the
PPPoE service.
[Setting method]
Click the button on.
[Default value]
OFF
Account
PPPoE user name provided by the
network carrier.
[Setting method]
Enter a value manually.
Password
Password provided by the
network carrier.
[Setting method]
Enter a value manually.
Step 3 Click Apply.
If the message "Apply success" is displayed, click OK. The system saves the
settings.
If other information is displayed, set the parameters correctly.
-----End