Method 1：Click left mouse button to select any time point within 0:00-24:00 from
Monday to Sunday as shown in Figure 8-14.
Method 2：Hold down the left mouse button, drag and release mouse to select the
deployment time within 0:00-24:00 from Monday to Sunday.
When you select time by dragging the cursor, the cursor cannot be moved out of the time
area. Otherwise, no time can be selected.
Method 3：Click in the deployment time page to select the whole day or whole
week.
Deleting deployment time: Click again or inverse selection to delete the selected
deployment time.
Step 8 Check Channel Record. Select a channel ID, input the post record to enable record
linkage.
Step 9 Check Channel PTZ. Select a channel ID and preset to enable PTZ linkage. Click
to add another Channel PTZ.
Step 10 Check Alarm Output. Select alarm output channel ID and alarm output time(s) to
enable alarm output linkage.
Step 11 Check Send Email to enable email linkage.
Step 12 Click Apply. The message "Apply success" is displayed.
Step 13 Click OK. The system saves the settings.
8.3.8 Intelligence Analyse Alarm
The following functions are provided:
Enable intelligence analyse alarm
Set intelligence analyse schedule
Set alarm linkage
Take the following steps to set intelligence analyse alarm:
Step 1 Setting>NVR Setup>Channel>Intelligence Analyse Alarm.
The intelligence analyse alarm interface is displayed, as shown in Figure 8-15.
To Next Page
Loading...
Need help?
General
