WBOX Technologies 0E-4CHNVR2TB - IP Filter

Setting
Network Video Recorder(NVR)
User Manual
Issue V1.0 (2018-05-11)
67
Parameter
Description
Setting
Password
Password of the mailbox for
sending emails.
[Setting method]
Enter a value manually.
Sender E-mail
Address
Mailbox for sending emails.
[Setting method]
Enter a value manually.
Recipient_E-
mail_Address1
(Mandatory) Email address of
recipient 1.
[Setting method]
Enter a value manually.
Recipient_E-
mail_Address2
(Optional) Email address of
recipient 2.
Recipient_E-
mail_Address3
(Optional) Email address of
recipient 3.
Recipient_E-
mail_Address4
(Optional) Email address of
recipient 4.
Recipient_E-
mail_Address5
(Optional) Email address of
recipient 5.
Transport Mode
Email encryption mode. Set this
parameter based on the
encryption modes supported by
the SMTP server.
[Setting method]
Select a value from the
drop-down list box.
[Default value]
No Encrypted
Step 3 Click Apply.
If the message "Apply success" is displayed, click OK. The system saves the
settings.
If other information is displayed, set the parameters correctly.
-----End
8.6.4 IP Filter
Set the IP address in specified network segment to allow access or prohibit access. .
Step 1 Choose Setting > NVR Setup >Network Service>IP Filter.
Step 2 Click the button on to enable black and white name, The Black and White Name page
is displayed, as shown in Figure 8-28.