Weatherdock EasyTRX 3 - Distance Filter

Weatherdock AG Seite 22
www.easyAIS.com
Additional you can select on which port AIS and GPS data, received from the easyTRX3, have to
be forwarded OUT to connected devices.
Example of manufacturer default:
Baud rate:

NMEA1: 38400 Baud for IN/OUT

NMEA2: 38400 Baud for IN/OUT

NMEA3: 4800 Baud for IN/OUT
Routing:
GPS data were forwarded to

NMEA1 – e.g. chart plotter

NMEA2 – e.g. chart plotter

NMEA3 – e.g. VHF radio

N2K – board network

USB – e.g. Laptop or PC

WiFi – e.g. Tablet or other terminal device
AIS data were forwarded to

NMEA1 – e.g. chart plotter

NMEA2 – e.g. chart plotter

N2K – board network

USB – e.g. Laptop or PC

WiFi – e.g. Tablet or other terminal device
INPUT data on NMEA3 (e.g. log or wind) were forwarded to

NMEA1 – e.g. chart plotter

NMEA2 – e.g. chart plotter

USB – e.g. Laptop or PC

WiFi – e.g. Tablet or other terminal device
Once you found the best personal setting, please press “Save”.
Distance Filter
The above shown screen copy also displays an activated distance filter. By using this functionality
you will be able to un-show AIS objects which are out of the selected distance range. This can be
useful in areas with high traffic volume to reduce the total amount of displayed objects on your
screen.
The distance filter can be used independently for NMEA and/or USB and WiFi. It is also possible
to use only one filter out of these two.
After you found your settings, please press “Save”.