Weatherdock AG Seite 70
www.easyAIS.com
9.4 WiFi - integrated WiFi module (optional)
While using the corresponding product variant, all data feeded into the easyTRX3 are forwarded
via WiFi connectivity to mobile terminal devices, e.g. smartphones or tablet
The module is ready for up to 40 mobile clients connected to the easyTRX3 simultaneously.
9.5 DVBT - integrated frequency splitter for TV signal and FM radio
(optional)
This optional product variant enables to separate the encrypted DVB-T2 signals by a frequency
splitter. These signals were forwarded to a connected DVB-T2 receiver. The reception of these
signals will be realized via the existing VHF antenna you are already using for VHF radio and AIS.
To receive DVB-T2 or FM radio signals, the easyTRX3 must be switched on.
Attention, there must not be another splitter between the antenna and the easyTRX3, because
the DVBT2 frequencies may be completely disconnected and therefore nothing can be received
or amplified by the easyTRX3.
10 Installation of the easyTRX3 aboard
Before mounting, please check GNSS window in Programming-Tool or App if you receive a good
GPS signal before fixing the unit on board. Otherwise change the position of the easyTRX3 or
use an external GPS antenna.
If you want to mount the easyTRX3 under-deck, you have to take care that the unit will be
strictly above waterline because of the integrated GPS antenna ā in case you are going to use it.
Keep in mind of the potential slope of the vessel when sailing close-hauled course.
The easyTRX3 is ready for outside mounting by means of IP67.
Please pay attention that the easyTRX3 has to be mounted with at least 40 cm distance to a
compass or other technical equipment.
To Next Page
Loading...