because it is permitted in this area. Please
inform by yourself in case of using long-range
AIS.
Once leaving the range of the base station,
and the long-range AIS was activated before
the automatic shutdown, the easyTRX3 will
re-activate automatically.
As long as you are not charged for satellite
data providing costs, the long-range AIS
position reports are not shown up at
Vesseltracker.com or MarineTraffic.
Vice versa there are no additional costs for
you if the functionality is activated.
At this point it is selectable with which baud
rate the NMEA ports have to work with. You
can select between 4800 baud, 38400 baud or
even 115200 baud. It is possible to set
different baud rates for the different ports.
Important to know:
Each port runs with similar data rate
for IN and OUT. This means that it is
possible to connect different devices
for IN and OUT at the same port, but
the baud rate of these connected
devices has to be similar.
The following matrix (manufacturer default)
is for configuration of device routing. Here
you can decide on which port data will be
feeded IN and on which port these data have
to be forwarded OUT to connected devices.
Change the default routing by clicking into
the different cells to display your personal
setup aboard.
To Next Page
Loading...
