Weatherdock EasyTRX 3 - 13 Troubleshooting

Weatherdock AG Seite 74
www.easyAIS.com
13 Troubleshooting
Problem
Cause
Solution
no connection possible to
easyTRX3

USB cable not plugged
correctly

USB driver not installed.
Make sure, there is an internet
connection, so the PC can download
the USB driver.
Try to use another USP-Port, we
recommend an USB-Hub with its
own power supply.
Proper configuration?
repeat configuration, perhaps you
have to ask your service partner.
No data output
not connected
Please check if cable colours are
correct for connection.
Is data output of the easyTRX3
connected with chart plotter data
input?
Please check baud rate of NMEA
output where chart plotter is
connected to.
Input of MMSI not possible
Perhaps already done?
Only 1 MMSI usage is possible. For
entering a different MMSI, please
ask your service partner.
Red Error LED glows
different errors possible
Please connect with the
programming software and look out
for „Diagnostics”.
If you can’t solve the problem,
please contact your service partner.