Important notice
5661290000/00/06.08
13
Figure 2 Warning label on device
CAUTION!
Do not open the printer!
Do not open the printer cover!
This exposes you to a risk of injury!
There are no serviceable parts inside
the printer.
You will forfeit all rights under the guar-
antee if you open the cover!
2.3 Safety precautions
Read the following instructions carefully before start-
ing up the PrintJet PRO. Observe the warnings and
notices on the PrintJet PRO at all times.
Read Chapter 4 „Initial commissioning“ for
more information.
• The printer weighs approx. 32 kg. Therefore, al-
ways use two people when moving. To lift the
printer, use the recessed grips at the front and rear
of the device.
Read Chapter 4.1 „Unpacking“ for more
information.
• Do not block or cover openings in the housing of
the PrintJet PRO.
• Do not insert any unsuitable objects into these
openings.
• Do not spill any fluids onto the PrintJet PRO.
• The mains voltage must correspond to the system
voltage given on the PrintJet PRO type plate.
• Do not open the device when it is printing!
CAUTION!
Only connect the printer to a properly-
earthed and correctly-fused socket out-
let. Do not use a socket outlet already
being used by devices that are turned
on and off at regular intervals, such as
photocopiers or fans.
Do not connect the PrintJet PRO to ei-
ther a switched or a timer-controlled
socket outlet.
CAUTION!
Do not use the computer system near
possible electromagnetic disturbance
fields such as loudspeakers or base
transceiver stations for mobile tele-
phones.
To Next Page
Loading...
