Printer description
22
5661290000/00/06.08
[▲] [▼] buttons
These buttons can be used to raise or lower the set-
ting values on the display.
By holding down one of the buttons, you can quickly
raise or lower the displayed value in increments of
10.
[ ↵ Enter] button
Press this button in order to execute the menu
command shown on the display.
Heating 1
Display and set the fuser setting 1.
LED illuminated: Fuser setting 1 is activated.
Heating 2
Display and set the fuser setting 2.
LED illuminated: Fuser setting 2 is activated.
Heating 1 and Heating 2
Both LEDs are illuminated: 3. Fuser setting level is
activated.
Loader
Turn on and display the loader function.
Inlay
Turn on and display the inlay function.
LED illuminated: Inlay mode is activated.
LED is off: Inlay mode is not activated.
Temp LED
Status indicator of temperature in the fusing unit.
Status / Error display
Status indicator when printing. A blue LED lights up
to indicate that an error has occurred that prevents
further printing or if a print job is sent before the Mul-
tiCard was drawn into the printer. An orange light in-
dicates that an error has possibly occurred during
printing.
If the blue LED lights up follow the instructions on
the display, when applicable.
Data In LED
This LED flashes when the printer is receiving data
from the computer. The receive display is illuminated
when pending data is waiting to be printed.
Transport LED
Indicates the status of or an error in the transport
system.
To Next Page
Loading...
