Weidmüller PrintJet PRO - Page 92

Troubleshooting
92
5661290000/00/06.08
Close Top Cover or reset the Duplex Unit cor-
rectly
A cover or lid is open or not seated correctly. Close
all covers and make sure they are all seated cor-
rectly.
Offline
The printer is offline. The printer must be switched to
online before printing.
Load Paper: Tray# or Form Feed
The loader is empty or the print system is currently
heating up.
Fill the loader.
Remove Misfeed Bypass
Reset the driver settings using the
M-Print
®
PRO software. This will re-establish the
correct settings.
Remove Misfeed Duplex
Reset the driver settings using the M-Print
®
PRO
software. This will re-establish the correct settings.
Remove Misfeed Tray 1
There is a paper jam in the loader. Clear the jam in
the loader.
Remove Misfeed Top Cover
Reset the driver settings using the M-Print
®
PRO
software. This will re-establish the correct settings.
Right Front Cover is open/Close Right Front
Cover
A cover or lid is opened. Close all covers and lids.
Remove Misfeed Output
Reset the driver settings using the
M-Print
®
PRO software. This will re-establish the
correct settings.
Remove Misfeed Guide Board
Reset the driver settings using the
M-Print
®
PRO software. This will re-establish the
correct settings.
Temp. alert Please wait...
The printer is either too hot or too cold and can not
start up. Wait until "Ready" appears in the operating
panel.
Ink depleted
The inserted ink cartridge is empty.
Replace the ink cartridge.
Reset Cartridge
No ink cartridge has been installed. Properly install
the ink cartridge.
Dry Waiting...
Reset the driver settings using the M-Print
®
PRO
software (refer to the M-Print
®
PRO manual).
Cannot use High Temp./Power Off On
The temperature is abnormally high.
Turn the printer off and then on again. If the mes-
sage is still displayed, contact your The Weidmüller
service or sales representative.
Cannot use Low Temp./Power Off On
The temperature is abnormally low.
Turn the printer off and then on again. If the mes-
sage is still displayed, contact your The Weidmüller
service or sales representative.