上海维宏电子科技股份有限公司
SHANGHAI WEIHONG ELECTRONIC TECHNOLOGY CO., LTD.
4 / 97
1.2.1 Button Definition
The definitions of buttons on NK105G3 handheld box are as follows:
• A single button
– : It is used to start machining.
– : It is used to pause machining.
– : It is used to stop machining.
– : Arrow button (up).
– : Arrow button (down).
– : Arrow button (left).
– : Arrow button (right).
– : It is used to enable / disable the spindle.
– : It is used to enter the menu interface, or enter the interface for
updating the system image at the time of starting NK105.
To Next Page
Loading...
