上海维宏电子科技股份有限公司
SHANGHAI WEIHONG ELECTRONIC TECHNOLOGY CO., LTD.
25 / 97
3. To enter the axis interface, select 1. Back REF Point by pressing /
, and press :
4. Select the target axis by pressing / , and press .
Note: For safety, it is recommended to return Z-axis first, or the prompt Dangerous operation, you’d
better home Z first. Continue? appears.
4.2 Load a Program File
This operation is used to load a program file in the host or a USB flash disk for
machining. The supported file format includes NC, ENG, DXF, PLT, TAP and TXT.
Taking loading a program file in a USB flash disk as an example, to load the program
file, do the following:
1. To enter the menu interface, press .
To Next Page
Loading...
