上海维宏电子科技股份有限公司
SHANGHAI WEIHONG ELECTRONIC TECHNOLOGY CO., LTD.
24 / 97
4 Quick Start
Through this section, you can quick know the machining procedure of NK105, and
then start machining.
To start machining, do the following:
1. Execute returning to the machine origin.
2. Load a program file.
3. Select a WCS.
4. Define the workpiece origin.
5. Set the tool number. (General NK105 with double Z axes)
6. Execute fixed calibration. (General NK105 with double Z axes)
7. Start machining.
8. Adjust machining.
4.1 Execute Returning to the Machine Origin
If returning to the machine origin fails due to the origin fault, set the parameter
Back REF First to No. See Returning to the Machine Origin before Machining for
details.
To execute returning to the machine origin, do the following:
1. To enter the menu interface, press .
2. To enter the operation interface, select 3. Operations by pressing /
, and press .
To Next Page
Loading...
