上海维宏电子科技股份有限公司
SHANGHAI WEIHONG ELECTRONIC TECHNOLOGY CO., LTD.
17 / 97
3.2 Select the Axis Mode
This operation is applicable to general NK105 with double Z axes.
The axis mode includes the following:
• Alternative mode: You cannot activate Z1-axis and Z2-axis at the same time.
• Linkage mode: You can activate Z1-axis and Z2-axis at the same time.
To select the axis mode, do the following:
1. To enter the interface for selecting the axis mode, press + .
2. To select the target mode, press / → . The selection
immediately takes effect.
3.3 Activate the Axis
This operation is applicable to general NK105 with double Z axes. Z1-axis and Z2-
axis are activated at the same time by default.
To activate the axis, do the following:
1. To enter the interface for activating the axis, press + .
2. To select the target axis, press / → . This screen
automatically turns to the main interface and Z axes lift up (workbench travel-
1):
The axis with a black background is activated.
To Next Page
Loading...
