上海维宏电子科技股份有限公司
SHANGHAI WEIHONG ELECTRONIC TECHNOLOGY CO., LTD.
30 / 97
4. Execute fixed calibration for Z1-axis and Z2-axis in turn. After calibration, the
coordinates of Z1-axis and Z2-axis are the workpiece origins of Z1-axis and Z2-
axis.
About fixed calibration, see Execute Fixed Calibration.
4.5 Set the Tool Number
This operation is applicable to general NK105 with double Z axes. And it is used to
set the same tool number for Z1-axis and Z2-axis.
To set the tool number, do the following:
1. To enter the menu interface, press .
2. To enter the operation interface, select 3. Operations by pressing /
, and press .
3. To enter the interface for setting tool number, select 10. ToolNo Set by
pressing / , and press .
4. Select the target axis by pressing / , input the tool number
with the handheld box and press .
After setting the tool number, in the idle / running status, to check the tool number,
press / in the main interface.
To Next Page
Loading...
